[Steps] How to Unbrick Yu Yuphoria Soft Bricked Device Easily [Lettuce]

In this guide we will guide you How to Unbrick A soft brick Micromax Yu Yuphoria [lettuce] easily.This is a Full Step by step guide of unbricking  Yu yuphoria.This will help to solve problem of your device when it stuck in YU bootlogo or it goes bootloop and follow below guide to Recovery your device.


#Whats is Soft Bricking ? 

When your Phone starts and stuck on the Yu logo it means your device is soft bricked
#What is Hard Bricking?
 When Phone does not start even if the battery is full. Have to go to the service center.

Note:
1.Make sure that you have 70-80% battery on your phone.
2.You need a PC and a USB cable to connect your phone to the PC.
3.Flashing the factory firmware will wipe all the data present in the internal memory. So, make a backup of that if you can.

 
#Required Downloads
 

1.Download the flash tools.
2.Download the factory firmware (signed fastboot) from the official Cyanogen Support Page.
3. adb setup drivers.
4. Mirror for drivers manual install here.

 

#Steps To Flash Stock Factory Firmware in Yuphoria
 

1.Extract the flashtools zip in a new folder on the desktop.

2.Extract the factory firmware zip in the same folder and 

make sure that all of the flashtools files are also present.

3.Now, power off your phone. If you are stuck in a bootloop, then pull out the battery and reinsert it. (Do not switch on the phone.)


4.While pressing the Volume Up key, connect your phone to the PC with the help of a USB cable.

 

5.You should now see the fastboot logo on your device. If you did, leave the Volume Up key. (If you do not see the logo, retry the process.)
 

6.Now go to the folder where you extracted the flash tools and factory firmware and run the flash-all.bat by double clicking on it.
 

7.A command window will open and the flashing procedure will start. (Make sure that your device does not disconnect from your PC during the procedure.)
 

8.The command window will automatically close once the procedure is completed.
 

9.Disconnect your device and boot it up by pressing the Power button. The first boot might take around 5-10 minutes to complete.
Previous
Next Post »

6 comments

Click here for comments
December 15, 2015 at 8:53 AM ×

I have download wiley fox cm-12.1-YOG4PAS3MG-kipper-signed-
fastboot.zip will it OK for my yuphoria ?

Reply
avatar
September 3, 2016 at 4:05 AM ×

but dubbing mode is off and that's why while flashing its say "device not found"

Reply
avatar
Surjit Raju
admin
December 2, 2016 at 7:44 AM ×

what can I do.. I got "Waiting for device" and nothing after that...?

Reply
avatar
Unknown
admin
February 22, 2017 at 7:22 PM ×

Install Adb Driver Properly

Reply
avatar
Unknown
admin
February 22, 2017 at 7:23 PM ×

Please install ADB Driver properly

Reply
avatar
Unknown
admin
September 18, 2017 at 6:14 AM ×

cm 12.1 signed zip is not available in your website

Reply
avatar
Thanks for your comment
This website is not affiliated with Micromax Yu Yureka in any way all rights are reserve to them ! We are here to help you with love.